Description

Steel Seal is a high quality product formulated to provide a hard surface finish and will stop and prevent rust or corrosion. It has proven to resist all type of acids, fuels, salts and even hydrogen sulfide. Steel Seal has successfully been used in the prevention of salt or brine corrosion in the off and on shore oilfield industry and is presently being used in all types of applications for salt corrosion. This industrial rust coating can be applied as a stand-alone product or used as a base for other coatings. It forms a non-permeable watertight seal over metals and will stop rust or corrosion. It is environmentally safe and non hazardous. No protective equipment is needed to apply Steel Seal. It is a water-based product allowing for easy clean up.
  Advantages
  • Requires No Mixing
  • Fast Drying
  • High Elasticity
  • No need for primers or sand blasting
  • Water Based
  • Permeability rating 0%
  • UV Protected
  • Stays flexible
  • Environmentally Friendly
  Field of Application

Steel Seal can be applied to any rigid metal surface to stop and protect from corrosion. It can be used on storage tanks, bridges, and offshore structures; anywhere rust and corrosion is a problem.

  • Metal or Metal Structures
  • Storage Tanks
  • Inland & Offshore Structures
  • Bridges
  • Suitable for domestic and industrial use
  Service Conditions
Steel Seal stays pliable to 10 degrees below and is serviceable to 180 degrees.
  Technical Data

Type - Blend of Latex Emulsions
Volume Solids - 54%
V.O.C. - .104 lbs per gallon
Weight per Gallon - 8.8 pounds
Physical State - Liquid
Appearance - Milky When Wet - Clear When Dry
Flammability - Steel Seal is not Flammable or Explosive
Coverage - Varies - 150 to 250 square foot per gallon
Dry Time - 15 Minutes to 1 Hour, Depending on Conditions
  Application
  1. Mix - No mixing necessary
  2. Thin - Do not thin.
  3. Surface Preparation - Remove all dirt and loose scale from surface. Pressure wash or clean properly before application. Allow surface to dry.
  4. Spray - Airless Sprayer - Use 2000 psi with 517 tip.
  5. Brush – Generously apply with any clean brush.
  6. Roller - Use a long knap roller
  7. Clean Up - Soap and Water
  8. Temperature - Above 45 degrees and rising.
  9. Storage - Do not store in direct sunlight or allow product to freeze.
  10. Flash Point - N/A

After applying first coat STEEL SEAL allow coating to dry (milky when wet clear when dry). After first coating is dry, apply second coating. Apply any decorative paint thereafter second coat is dry.